The LED Light Ring on the DEWALT® DCG426 Cordless Die Grinder gives off about 10 lumens for your work area.
Traditionally, serial numbers for DEWALT cordless tools have been located on the ID label on the side of the tool.
Moving forward, some of the new cordless products may relocate to the more protected area where the battery is inserted for use.
It could be that the pad is worn out and needs to be replaced.
Your pad has a number of tiny hooks on the bottom of it that grip the felt backing on the sandpaper and over time, these hooks deteriorates and the pad will need to be replaced. To maximize the life of the pad, let the sander do the work for you. Applying pressure as you sand can deteriorate those hook much faster, but take away part of the orbital action of the sender as well. If it's been a long time, it is also a good idea to change the CFS disk (or brake) at the same time.
To locate the model and type of your sander, it is on the label on the side of your sander.
The volume/flow rate the DCGG571 grease gun is capable of is 5 ounces per minute. To break that down further, it can dispense 0.4cc per piston stroke
There are different kinds of flexible cable so let's clarify.
If it is THHN or XHHW flexible cable, then yes, the DCE151 will work great on it.
However, flexible welding cable, with much thicker rubber jacket the DCE151 will not work on it.
The DEWALT steel measuring tapes are made of a C1095 steel alloy and hardened to R15N 83-86 which is equivalent to Rc 38-45
The DCB104 is a 4 port simultaneous fast charger for DEWALT 12V MAX, 20V MAX, and FLEXVOLT® batteries. The maximum power draw is indicated on the bottom housing of the DCB104: 120VAC @ 10A = 1200 Watts. Actual power draw would approach this if four FLEXVOLT batteries were being simultaneously charged. The approximate peak power draws when charging 4 x DCB206 should be about 800 Watts.
The press jaws of the DEWALT® DCE200 Press Tool are made of a black galvanized coated steel making them much less susceptible to corrosion than some other brands.
Internal Only
The tip speed on the DEWALT® DCST920 String Trimmer is 16,000 - 21,000
The DEWALT Jobsite WiFi system has a variety of methods to inform you if the Access Point is experiencing poor connectivity - including via the app, web, and the LED light indicator on the Access Point itself.
Typical causes of degraded performance during the construction process include pouring large concrete forms, installing glazing, and other large structural changes that hinder the line of sight between Access Points. In the event you experience degraded connectivity, here are some things you can try:* Move the Access Point at least 10’ (3m) away from large obstructions
Make sure that the password is correct and check the LED on the Access Point to ensure it is solid green. If you are far away from an Access Point, try moving closer.
In a mesh network, there are multiple Access Points but your device will only connect to one Access Point at a time. As you walk around the site your device will remain connected until you are far enough away from an Access Point that your device seeks a new one to connect to. The decision to connect to a particular Access Point is determined by your device, so if you are moving you may not be always be connected to the closest Access Point. Toggling the WiFi on your device off and on will force the device to connect to the closest Access Point and help improve your performance.
You can factory reset the DEWALT Jobsite WiFi Access Point by pressing and holding the reset button next to the LED light for twenty seconds. The Access Point will briefly reboot and will come back online, unconfigured from any WiFi mesh networks.