Products
- Charging and Jump Starting Systems
- Antizap Surge Protection
The Goodall Start-all units provide the perfect combination for jump starting and battery charging for your vehicle or equipment.
Start•All Charging and Jump Starting Systems
450 Amps • 12 Volts
Powerful 12V or 12/24V jump-starting and battery charging for those who need to keep residential and off-road construction equipment, transit buses, and other 24V powered vehicles up and running, even in harsh conditions. Commercial grade 450 amp system perfect for jumpstarting 12V vehicles.
ENGINE: Electric Start, Air Cooled Briggs and Stratton® Vanguard™ OHV Gas Powered with 2 gal. Fuel Tank and Low Oil Shutdown
JUMP STARTING: 12 volt, 450 AMP
CABLES: 30" 1/0 Gauge
CLAMPS: 1 A
DIMENSIONS: 27" W x 23" D x 24" H, 273 lbs.
The Antizap surge protector provides protection for delicate electronics against transient voltage spikes or voltage surges. Eliminates the need to disconnect the battery from the terminal while welding.
AntiZap
Eliminates the need to disconnect the battery from the terminal while welding. Provides protection for sensitive electronics.
Protects vehicle electronics during MIG, TIG, or Argon Arc welding Fully insulated booster clamps with 2-function AntiZap™ protection Eliminates the time needed to disconnect the battery Just clip the clamps across the battery and the green LED indicates complete electrical system protection
Ensure your vehicle is correctly grounded before welding.
The AntiZap™ Surge Protector will not protect against induced current created by incorrect welding procedures. Always follow manufacturer’s instructions. Additional AntiZap™ surge protection may be required for accessories wired into the vehicle’s wiring harness between the point of weld and the battery. If in doubt, seek the advice of an electrician prior to welding. Goodall Mfg.’s warranty is limited to the replacement of a defective product. Goodall shall not be liable for any consequential or incidental damages.
Antizap Booster Cable Upgrade
The AntiZap surge protector provides protection for delicate electronics around transient voltage spikes or Voltage surges. 12/24 heavy unit duty that fits up to 3/8" diameter or 2/0 gauge cable.
For heavy duty jumper leads 12 and 24 volt protection LED's indicate correct polarity and low voltage at donor battery Suits cable 3/8" diameter or 2/0 gauge cable.
Protects while jump starting:
EFI and Engine Management System Climate Control Stereo and CD Players GPS and alarms SRS airbags ABS brakes Instrumentation Both donor and dead vehicles
Warranty: General One Year
Ensure your vehicle is correctly grounded before welding.
The Antizap Surge Protector will not protect against induced current created by incorrect welding procedures. Always follow manufacturer’s instructions. Additional Antizap surge protection may be required for accessories wired into the vehicle’s wiring harness between the point of weld and the battery. If in doubt, seek the advice of an electrician prior to welding. Goodall Mfg.’s warranty is limited to the replacement of a defective product. Goodall shall not be liable for any consequential or incidental damages.